Operating guides and technical references — antenna install, pool forwarding, frequency tuning, hotspot recovery and more.
Layout rules, colours and widget sizes for building your own screens on a U1 or U2 — plus the online design tool and a downloadable UI set.
Read →An unlocked debug build without the hardware frequency lock, released for testing. Read the caveats before you put it on a board you care about.
Read →On that build the device expects a specific SSID and password. Rename your access point, restart, and the miner joins again.
Read →A bad static IP can make the miner unreachable on your network. Step-by-step recovery back to the settings page.
Read →Where the frequency setting lives in the web UI, what to change, and how to tell whether the board is stable at the new value.
Read →Move the resistor from position 1 to position 2 to switch the module to the external antenna connector, then fit the antenna.
Read →Point the miner at a pool through redir so no fee is skimmed. Worked example with a public pool, plus the supported protocol.
Reprinted piece: why running an access point at full power is often worse than a lower setting, especially with many miners on one network.
Read →From a random 256-bit number to a Base58 address — the hashing steps and checksum, written out for reference.
Read →中文版：更换电阻位置并接上天线接口。English version is listed above.
Read →中文版：用 redir 把矿机指向自己的矿池，无抽水。English version is listed above.
Read →Dates are the original publication dates carried over from the previous site; content is reproduced as published.
